PDA

View Full Version : Mech Ideas Longblast kit for RTS Jazz


snaketales
6th February 2013, 03:35 PM
Recieved this kit this week. I think it's an homage to alternators Shockwave (dont know much about that line sorry).


http://i49.tinypic.com/156bd3n.jpg
The kit arrived in this paper envelope....

http://i49.tinypic.com/od5c.jpg
...with a nice story on the back.

http://i49.tinypic.com/2w6yr9d.jpg
Inside was this - a sticker sheet, Longblast head and barrel and little Megatron and Shockwave guns that can be held by any figure with 5mm fist holes. I think these alone are worth getting the kit for. There's no map for the stickers. 95% of them are obvious, but there's two that I have no idea where to put. :confused:

http://i45.tinypic.com/37mw.jpg
Here he is after the stickers have been applied, but before I repainted the grill and put faction logo stickers on. Before putting the stickers on I used rubbing alcohol to take Jazz's racing stripes off.

http://i46.tinypic.com/2zdpzmc.jpg
http://i50.tinypic.com/2v3hc9w.jpg
Unfortunately the Jazz mold isn't too kind to stickers. One of the bonnet pieces was folded during transformation, and one of the door stickers (you can see it on the bottom left corner of the door hnge) was damaged during transformation. Of course it could be my own fault....

http://i47.tinypic.com/6gm0qt.jpg
And here's robot mode. Now I could have painted the rest of Jazz purple, but there's lots of areas for paint rub and I don't need the aggravation. I think the stickers and new head set Longblast apart enough.

http://i47.tinypic.com/5a5f04.jpg
UltraMarginal
6th February 2013, 03:41 PM
that actually looks a lot better than I expected it to, thanks very much for sharing Snaketales.
snaketales
6th February 2013, 05:11 PM
Forgot to mention, changing the head is just a matter of unscrewing Jazz's head, sliding it off the ball joint, then pushing Longblast's head on top.

Jazz's hand has a ball joint that fits into a socket on his hand. I found it hard to get this off, so I soaked it in just-boiled water for 2-3 minutes then was able to pull it off. The gun barrel has a ball joint that plugs into the socket.
1orion2many
7th February 2013, 12:50 PM
:confused:Shockwave in car form just seems odd or is that just me:confused:
Bidoofdude
7th February 2013, 05:56 PM
:confused:Shockwave in car form just seems odd or is that just me:confused:

It's a nod to the Alternators Shockblast toy. Actually looks quite interesting with the sticker doors.:cool:;)
Gouki
7th February 2013, 06:32 PM
It looks okayish for what it is, but really, it's not overly successful.
Paulbot
7th February 2013, 10:59 PM
It's also a ripoff, I mean inspired by, the BotCon customising class Longarm (http://tfwiki.net/wiki/Longarm_(SG)).
Bidoofdude
8th February 2013, 10:48 PM
It's also a ripoff, I mean inspired by, the BotCon customising class Longarm (http://tfwiki.net/wiki/Longarm_(SG)).

So he's a heroic Decepticon disguised as an evil Autobot? Or is it opposite in the mirrorverse?:confused::o
kup
9th February 2013, 08:58 AM
A bit of a niche idea but not my thing. The head sculpt is cool though so it would work for customizers.
Tetsuwan Convoy
9th February 2013, 03:45 PM
interesting. Does the laser hand fit inside the vehicle mode OK, or do you have to unplug it al the time?
Omega Metro
9th February 2013, 05:36 PM
Stickers make it look tacky.
snaketales
12th February 2013, 10:13 PM
interesting. Does the laser hand fit inside the vehicle mode OK, or do you have to unplug it al the time?

The laser hand fits OK. No need to unplug it.
crankcase76
19th February 2013, 10:35 PM
Received my Longblast kit today and found a few of the problems Snaketales posted are infact the manufacture of the upgrade, the stickers on the doors are one. Found that if you apply the sticker and trim it up with a blade it will sort out the problem, also most of the stickers overhang like the pics that were posted so again they need to be trimmed. Other than that it does go well with the collection.:D so here are my pics.

http://i1219.photobucket.com/albums/dd430/megatron84/DSC05731_zps0b7b0ce0.jpg

http://i1219.photobucket.com/albums/dd430/megatron84/DSC05725_zps823785de.jpg

http://i1219.photobucket.com/albums/dd430/megatron84/DSC05723_zps0b66d78b.jpg
chuttla
21st February 2013, 08:22 PM
i dont mind it, im curious to see what he looks like before the long blast stickers go on though (with jazz' stickers and paint apps removed)
CHILENO20
9th April 2013, 03:03 PM
I'm waiting for mine to come, sheould be here within the month. I've actually painted mine so I can put it with my CHUG's. I'm waiting to see how different the sticker coulour will be to the paint I've used. It may give it that two tone look but we'll see. Once it's done though, should I post the pictures here or in the creative section???