Custom Meister

Quote:

---

hahaha... there's no such thing as "kph" - the proper abbreviation is km/h

---

whoops, I was just cutting and pasting there. Bear in mind the size, none of it is going to be seen clearly anyway.

Quote:

---

Woah! That Illustrator file with the logos looks amazing. Would you be happy to share that?

---

Only if you say pwease.

Quote:

---

Originally Posted by gamblor916

Only if you say pwease.

---

"Please" PM'd

Quote:

---

Originally Posted by gamblor916

Only if you say pwease.

---

please Gamblor sir, may I have it as well? :)

Small update. I didn't like the profile of the front arch so back to the putty again.

http://img516.imageshack.us/img516/5458/p3210023by1.jpg

Removing the pin for the roof was scary, so careful not to break the hinge or clear bits.

http://img262.imageshack.us/img262/7182/p3220029sl6.jpg

The rear wheel arch had too much of a gap so I glued strips of styrene sheet to fill it out a bit.

http://img262.imageshack.us/img262/9703/p3230036ib3.jpg

I also sprayed up a lot of parts in Mazda galaxy gray.

http://img262.imageshack.us/img262/9607/p3230039rn8.jpg

Progress is being made! :)

Woo Hooooooo!!!

Now, about that old-school supercharger...

nice grey paint :)

:confused:Have you got any further on this custom:confused:

Thanks for digging this back up :)
It's still not where I would like it to be, there's still some surface blemishes I have to fix. Plus all that rain wasn't good for spraying.
I was hoping to spray more primer this weekend, sand, then black then gray the following week. After that decals, clear and finish, that's the plan anyway.
More progress soon hopefully ;)

:)I'll send a Dominatrix around to whip you so you finish customising this figure sooner:p:D.

umm this?
http://img211.imageshack.us/img211/4...liewhiplh2.jpg

I took some more pins out. The ones for the rear doors and the swivel at the bottom were difficult but I managed to get them out and fix up the parts ok.
The decals came out nice, considering I used the wrong paper in the laser printer at work. Sealed it with a coat of clear.

http://home.exetel.com.au/leducly/images/P5160216.jpg

I just need one more primer coat to check that it's perfect then the colour coats can go on.

http://home.exetel.com.au/leducly/images/P5160222.jpg