Ahoy there fellow travelers !
Had a G1 Rodimus arrive with a broken peg (most likely from his gun) stuck inside the fist.
Any solid techniques to get this annoying little broken stub out?
Ahoy there fellow travelers !
Had a G1 Rodimus arrive with a broken peg (most likely from his gun) stuck inside the fist.
Any solid techniques to get this annoying little broken stub out?
I guess you either drill it with quite a smaller sized drill bit or put a screw in it part way and pull it out.
To drill it I would measure the depth of the hole, put tape below that depth on the drill bit (so you dont go too deep) and clamp the figure so you have two hands to control the drill. The drill bit would be 1-2mm narrower than the whole and any remaining plastic hopefully can be scrapped out.
"I am not a gun. I'm hitting people with a hammer. On Mars."
The Iron Giant / David Wildgoose
Hmmm lets see how it goes. Cheers fellas
I've used a small screwdriver to effectively hand-drill the core out. You can then apply some pressure inside the hollow core to drag it out of the fist without damaging the figure itself.
I had this happen a couple of weeks ago with MP Loudpedal and his stand, the little peg snapped of in the flight mode display hole.
I used a drill, its all about the right size, cleared it out in a sec, drill very carefully though and make sure if anything the drill bit is undersized.
I still function.....................while killing threads. ;-)