Custom Meister

[gamblor916]

hahaha... there's no such thing as "kph" - the proper abbreviation is km/h

whoops, I was just cutting and pasting there. Bear in mind the size, none of it is going to be seen clearly anyway.

Woah! That Illustrator file with the logos looks amazing. Would you be happy to share that?

Only if you say pwease.

[jaydisc]

Only if you say pwease.

"Please" PM'd

[Saintly]

Only if you say pwease.

please Gamblor sir, may I have it as well?

[gamblor916]

Small update. I didn't like the profile of the front arch so back to the putty again.



Removing the pin for the roof was scary, so careful not to break the hinge or clear bits.



The rear wheel arch had too much of a gap so I glued strips of styrene sheet to fill it out a bit.



I also sprayed up a lot of parts in Mazda galaxy gray.

[Pulse]

Progress is being made!

Woo Hooooooo!!!

Now, about that old-school supercharger...

[Saintly]

nice grey paint

[1orion2many]

Have you got any further on this custom

[gamblor916]

Thanks for digging this back up
It's still not where I would like it to be, there's still some surface blemishes I have to fix. Plus all that rain wasn't good for spraying.
I was hoping to spray more primer this weekend, sand, then black then gray the following week. After that decals, clear and finish, that's the plan anyway.
More progress soon hopefully

[1orion2many]

I'll send a Dominatrix around to whip you so you finish customising this figure sooner.

[gamblor916]

umm this?


I took some more pins out. The ones for the rear doors and the swivel at the bottom were difficult but I managed to get them out and fix up the parts ok.
The decals came out nice, considering I used the wrong paper in the laser printer at work. Sealed it with a coat of clear.



I just need one more primer coat to check that it's perfect then the colour coats can go on.