I'm in the process of restoring an original G1 Galvatron, and part of that process involves the re-chroming of 3 of his 4 chrome parts (fortunately, his '4 pack' is faultless). Before I even think about applying any paint (I won't be using comparatively expensive plating techniques) I'll need to remove the chrome that is there, as seen below.



To achieve this, I've gathered the following products:
-Latex gloves (not pictured)
-Easy-Off BAM @ $4.80
-Paper Towel
-Hard bristled Toothbrush
-Small Container
-Cotton wool bud (optional)



Here are the steps taken to remove the chrome:
Step 1: Put gloves on
Step 2: Place the 3 parts into the small container
Step 3: Pour enough Easy-Off BAM over the parts to cover them
Step 4: Using the cotton wool bud and/or toothbrush, brush over the remaining chrome paint until all gone (there is no waiting period required, the chrome paint will come off easy peasy like taking Energon candy from a Minicon)
Step 5: Wash the de-chromed parts in dishwashing detergent + warm water
Step 6: Rinse them under cold water
Step 7: Use paper towel to dry them off

All done! Just look how happy Galvatron is with the results.