Cliffjumper Upgraded!

[Borgeman]

heres mine up close:



see how the left one is a bit thinner, from what i cant tell it looks as if it was cut at a slight angle, as it gets thinner towards the end...

and heres a little combo i thought up - the Bumblejumper Blaster:





Edit: note how the rubsign is a solid red, thanks to our 41 degree day today :/

George

[kup]

I checked it again and indeed it does seem to have a lite deformity in the same place but although its less than yours, it isn't much either but it does angle in the same way. I am guessing that this is where the mold is injected hence the varying flaws. However mine is a bit more 'rough' on the surface where the red meets the silver.

Also how did you fit that piece of paper behind the red squares? On mine they make contact with the plastic so I placed glue behind them.

Still, your CJ looks awesome and the 'flaw' is hardly that as you only notice if you specifically look for it, we get worse things from bad HasTak QC.

[Borgeman]

mine doesnt actually make full contact, though the gap is so small i can only fit 2 slips of paper in - i guess it depends on how/where you applied pressure on the bumper.... i didnt glue that region abviously

also, the handle on my bazooka is unfortunately a bit thin, so its loose in both hand (and also b/bees hands as well)

so in summary - im the best :P

George

[Kyle]

...note how the rubsign is a solid red, thanks to our 41 degree day today :/

George

[kup]

Update of pics without the face deforming flash: