Ozformers Transformers Club of Australia


Go Back   Ozformers Transformers Club of Australia > Info and Activities > Ratchet's Repair Bay & ID/transformation Help

Sightings/Sales

Reply
 
Thread Tools Display Modes
  #1  
Old 5th October 2017, 10:36 PM
DELTAprime's Avatar
DELTAprime DELTAprime is offline
Rank 6 - Deluxe Member
 
Join Date: 12th Jun 2011
Location: Gladstone
Posts: 3,305
Default Misassembled TR and Legends Kup.

There was a story on Seibertron saying that every TR and Legends Kup is misassembled. What would be a good way to fix the error without sawing through the pin like they did in the article?

https://www.seibertron.com/transform...sembled/39710/
Reply With Quote
  #2  
Old 5th October 2017, 10:53 PM
DarkHyren's Avatar
DarkHyren DarkHyren is offline
Rank 5 - Dedicated Member
 
Join Date: 7th Jan 2010
Location: Sydney
Posts: 1,511
Default

Others have suggested that you can heat the pin holding the panel in place and then pop it off.
This post and this post over at seibertron mention the method they used.
Means you dont have to saw through anything but you'll still need a small soldering iron
Reply With Quote
  #3  
Old 12th October 2017, 07:32 PM
SMHFConvoy's Avatar
SMHFConvoy SMHFConvoy is offline
Rank 5 - Dedicated Member
 
Join Date: 28th Feb 2009
Location: Western Sydney
Posts: 1,556
Default

Just did the mod this evening using the craft saw, took 20 minutes and it only cuts through a plastic tube. I did manage to scratch the paint on wheel but I'm planning on painting the figure.

I would not recommend using an exacto knife for this mod!
__________________
Reply With Quote
  #4  
Old 28th October 2017, 06:34 PM
bowspearer bowspearer is offline
Rank 5 - Dedicated Member
 
Join Date: 24th Jun 2011
Location: Central Coast
Posts: 680
Default

A word of warning with the soldering iron option as I caused minor damage to one of the legs. If You are doing it, hold the iron there just long enough to get some slight movement on the legs and push in pulses rather than one hit - otherwise you risk warping the hole on the panel under the head of the pin.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +10. The time now is 11:55 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.