Diecast metal

[drifand]

The thing is.....they are saving cost on paint.

If its diecast you have to paint the metal. If its plastic you can decide to use the colour moulded plastic. Hope this makes sense, I didn't thought about it but realise they have been cutting corners with just that.

[Trent]

The thing is.....they are saving cost on paint.

If its diecast you have to paint the metal. If its plastic you can decide to use the colour moulded plastic. Hope this makes sense, I didn't thought about it but realise they have been cutting corners with just that.

Most of the MP cars are painted plastic. So is Takara MP-10. So no real cost saving there.

[drifand]

Most of the MP cars are painted plastic. So is Takara MP-10. So no real cost saving there.

I can find bits and pieces that are moulded colour not painted. This is where, it shows.

You sure about mp-10? I am quite sure the grey legs are plastic, and partial painted red? < I may be wrong but it does look like moulded colour rather than painted.

You are correct on the red, I believe.

Is the YOTH version arms painted or just darker red?

[CBratron]

Maybe some diecast for ballast in the feet or for small structural parts like in the middle of MP-10. Other than that, I don't really see a need for diecast parts in modern transformers.

I reckon modern plastics and structural design practices are sufficient for a solid transformer.

[drifand]

I agree, I wouldn't go "over" the top. I have toys in other lines where is full plastic and at high cost. It just doesn't feel justified for what you pay.

I dunno, purhaps people just don't mind paying high prices for all plastic toy.

Edit I just went to check on my mp10 it is moulded red rather than painted. Anyone wants to verify ?
The parts painted are actually the face, chrome parts, silver on body and the yellow arrows on hands. Most of the blue is plastic blue.

I looked at mp streak and yes almost everything is painted, only the red plastic, the silver fist and partial legs.

Well looks like I am just not happy with the paint work rather than diecast. I would admit that. But I did justify that the difference is for die cast, they are forced to paint as opposed to just using coloured plastic.

[Magnus]

I recently found out that part of MP22's torso/trailer deck is made of diecast metal. Since this is a pretty thin piece, and forms the 'foundation' of the robot mode's torso, I think it's a good example of using metal for strength.

[UltraMarginal]

I agree, I wouldn't go "over" the top. I have toys in other lines where is full plastic and at high cost. It just doesn't feel justified for what you pay..

The material cost is such a small amount of the overall cost of design and development of any product.

It does factor in, but when there are hundreds of hours going into design, development and prototyping of a product, the final material cost is a consideration but not a primary one.