Changing the gun and hand is pretty straight forward, all you'll need is an appropriate size* Phillips head screwdriver. Here's a step by step if you want to see what's involved:
- Remove three screws from right arm. The inside half of the arm can then be popped off. The hand just slips over a round post so swap it over and close it back up.
- Remove three screws from the left arm. Remove the battery cover and inside half of the left arm.
- Carefully slide out the gun barrel, switch, and battery compartment. The wiring can be quite fragile. If you don't care about the electronics, you can probably just insert the opaque barrel and reassemble the case, otherwise remove the small screw from the base of the barrel.
- The tip of the gun barrel can be popped off and the halves separated. Remove the LED and wires from the barrel. Disassemble the opaque barrel in the same way, install the LED then reassemble the barrel and arm. Don't forget to put the end of the hose back inside before you close up the arm.
Larger image
Sorry for the less than optimal lighting.
* Some people have reported that the screw heads might be prone to stripping if you use too large/small a screwdriver. A 1.8 mm jeweler's screwdriver fit perfectly for me.
Thanks! That will be very helpful reference for those who wish to swap parts.
A word of warning: If you have the backpack plugged in you may want to fold the gun sight slightly outwards so that it's not hard up against the small of his back. If folded all the way up, the backpack can scratch the silver paint on the sight when you rotate at the waist.
Mwuhahahahahaha!!!!!! My enemies are doomed!!!!
![]()
Dovie'andi se tovya sagain
Oh and this guy is pretty damned awesome. A very well executed figure.
![]()
Dovie'andi se tovya sagain