Personally I'm not going to bother with trying to switch the large wing connectors.

A. It's very difficult to get to the pins and I'm worried about cracking the plastic trying to tap them out.

B. It's easy enough just to un-peg the wings during transformation then peg them back into position once you've reached your desired Transform.


But for those willing to take the risk see the picture below for the pin locations. Just pull the chest flap forward as far as it goes and then move the arms out of the way. The try to use small thin screwdriver or small nail punch to tap the pins out. As I said before due to the angle you need to put the punch at you will more than likely damage the plastic pin surrounds.



Here's a pic (unmodified) where I simply un-pegged the wings during transformation then clipped them back in at the end. The sit nice and flush on the wing clips.