Quote Originally Posted by DaptoDog View Post
Ok Grinder is doing my head in. To people who have it, when I'm pulling out the tail from the inside the legs to transform to Dino mode, it gets caught on the bottom bit of plastic. I was able to pull out the tail from the left leg last night but noticed now that I've taken off a little bit of chrome on the end edge of the largest tail piece. The same thing will happen with the right leg so I haven't forced that one.

Is this an issue that anyone else has had? Mine doesn't appear to be misassembled, it just looks like there is no clearance.
I've not opened mine yet and won't get to it for a while, one thing I have found with Fans Toys product in the past is their tolerances are often very tight for moving one piece past another. Not being familiar with the toy yet, is it possible to adjust it some other way to then allow more clearance for moving the tail piece?

Quote Originally Posted by Trent View Post
Oh sure. Gloat about the fact that yours has a tail...
Say Whaat? perhaps I should open my Grinder and give it a quick look over to make sure it has all it's parts?