So very very sweet


Also, a neat way I found for cutting panels..
1. Use a stanley knife (art scapel is easier) to lightly score a groove into the "front/good" side of the panel

2. Repeat step 1 until you have a 1mm groove for most of the score. NOTE: I said repeat because there is a balance to how hard you can press on the knife before it jumps out of your nice neat groove.

3. Flip the panel over to the less important side and dremel with a gouging tip where the groove is until you see a white line from the knife cut.

4. Now you have a very thin join holding the panel together that you can bend, cut or dremel free. Yay! Also, the new edge of the panel can be quite thin now so you can thicken the dremeled side again with your bog of choice (WH green stuff etc..) to strengthen it from getting dinged.